Hi,
First I would like to say a big thanks to Matthias for this wonderful panel.
I can't believe that it's so complex and yet still freeware - but of course I am very happy that it is
Well I am having a bit of a problem when starting the engines - I think I follow the start-up procedures correctly, but I must be doing something wrong - I just can't tell what it is though.... I can start engines 1 and 4 OK, but 2 and 3 will crank up but not start.
I am reading the manual but cannot see anything relevant to my problem - does anyone have any idea what I might be doing wrong?
cheers,
GrahamW

Hi Graham,

I could find this information on the BAe146 page, FAQ list :

"I could not start engine 2 and 3."

This could happen if you flew another aircraft before the BAe 146 and you stop the engines with the mixture control, or if you have saved a cold and dark cockpit situation when starting. In this case sometimes the mixture controls of engine 2 and 3 stay closed. There are now two ways to activate them. Either you open the mixture control in another aircraft or you press the keys cntr+shift+F4 when the BAe 146 is loaded to switch on the mixture of engine 2 and 3. Now it should be possible to start all engines. This will be corrected with the next update.

Good luck,

Peter

Thanks Peter, sorry I didn't read the FAQs properly
I always shut it down completely to cold & dark, so I'll remember to do that ctrl+shft+F4 each time.
cheers,
GrahamW